200mm Full Ball Traffic Light Module（Low Power）
| Color | LED Qty | Wave length | Viewing angle | Power | Working Voltage | Housing Material | |
| L/ R | U/D | ||||||
| Red | 150pcs | 625±5nm | 30° | 30° | ≤15W | DC 12V/24V, AC187-253V, 50HZ | PC |
| Green | 130pcs | 505±3nm | 30° | 30° | ≤15W | ||
1. Novel design with beautiful appearance
2. Low power consumption
3. Light efficiency and brightness
4. Large viewing angle
5. long lifespan-more than 50,000 hours
6. Multi-layer sealed and waterproof
7. Unique optical system and uniform illumination
8. Long viewing distance
9. Keep up withGB14887-2011 and relevant international standards
1. Specifications:
The design of LED traffic light should comply with GB14887-2003 specification.
2. Light source:
The light source adopts imported chip four-element ultra-high-brightness light-emitting diode (LED), which has the characteristics of strong brightness, long life, good energy-saving effect, and easy identification by people.
3. Transparent design:
The outer surface of the light-transmitting lens is designed with an inclined surface, which is not easy to accumulate dust and can be used in various environments.
4. Appearance design:
The appearance is specially designed for the LED light source, the structure is ultra-thin and humanized, the appearance is beautiful, the workmanship is precise, and it is convenient for various combination devices.
5. Shell material:
The shell is made of die-cast aluminum or polycarbonate (PC) material and silicone rubber seal, which has the characteristics of dustproof, waterproof, flame retardant, anti-aging, and long service life.
1. LED traffic light consists of motor vehicle signal lights, non-motor vehicle signal lights and pedestrian signal lights. Motor vehicle signal lights must be set at LED traffic light intersections, and non-motor vehicle signal lights and pedestrian signal lights can be set up. Beijing generally sets up all types of signal lights.
2. LED traffic light poles are usually divided into cantilever type and column type. Motor vehicle signal lights generally adopt cantilever type, and pedestrian signal lights adopt column type.
3. The column height of the cantilever signal light pole is 6.4m, and the length of the cantilever is the length from the column to the center of the innermost exit lane. The distance between the column and the curb is generally 1m, and it is generally set at the tangent point of the curb curve, as close as possible to the stop line of the control direction. The number of the cantilever signal light pole is T6.4-8SD, which means 6.4m high outrigger 8m.
4. Motor vehicle signal lights are divided into round lights and direction lights. Generally, only round lights are installed at intersections that do not have special left-turn phases, and round lights and direction lights are installed at the entrance lanes with special left-turn phases.
5. Motor vehicle round lights generally have at least 2 groups.
6. Non-motor vehicle signal lights are usually attached to the column of the cantilever signal light pole, and set up 1 group; when the non-motor vehicle signal light is set on the column type light pole, it is set near the stop line of the entrance road.
7. Pedestrian signal lights are supported by 3m-high columns and are set at the end of the pedestrian crossing, about 1m away from the curb. When the distance between the two directions is relatively short, it is advisable to set them in parallel.
8. When the motor vehicle signal lights are supported in the form of columns, the height is 6m. At the same time, pedestrian signal lights or non-motor vehicle signal lights can be attached.
9. T-shaped intersection signal lights can be supported by 3m cantilever, 1.5m double cantilever, 6m column and other support forms. When using 6m column support, only one group of round lights can be installed.
1. Q: Can I have a sample order for LED traffic light?
A: Yes, we welcome sample orders to test and check quality. Mixed samples are acceptable.
2. Q: Is it OK to print my logo on LED traffic light products?
A: Yes. Please inform us formally before our production and confirm the design firstly based on our sample.
3. Q: How do you ship the goods and how long does it take to arrive?
A: We usually ship by DHL, UPS, FedEx or TNT. It usually takes 3-5 days to arrive. Airline and sea shipping also optional.
4. Q: Do you offer guarantee for the products?
A: Yes, we offer 3~5 years warranty to our products.
-
Phone
-
E-mail
-
Whatsapp
-
WeChat
Judy
-
Top